Tempest Tornado Manual do Utilizador descarregar pdf (Página 15)

Cyclone Enclosure User Manual page 15

Drainage

For base up/globe down or horizontal operation, a small drainage hole will be drilled in the globe,

to permit any water draining through the enclosure to exit harmlessly.

This will normally be done at the factory, but if done on site, YOU MUST USE THE APPROPRIATE

TAPERED DRILL BIT, OBTAINABLE FREE OF CHARGE FROM TEMPEST LIGHTING. A standard drill

bit may crack the plexiglass globe. Tempest Lighting will not be responsible for such damage.

Horizontal Enclosures – be sure to replace the globe with the drainage hole at the lowest point

after relamping.

Note: A tapered drill bit is included with all Tornado 1900-1950 shipments. Weep holes must be

drilled on site as part of the installation process.

36”/914mm

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Sem comentários

Tempest Tornado Manual do Utilizador Página 15